30
Install the LATCH/UAS Guides*
NEVER use if parts are broken or damaged.
NEVER use LATCH/UAS Guides if they interfere in any
way with installation.
Connect one guide,
if provided, to each
lower anchor by
sliding the guide
into the vehicle seat
crease and under
the lower anchor.
Install the Quick Connectors™
Lift pad off front edge of
seat.
Attach lower anchor/UAS
connectors to the vehicle
lower anchor bars until they
lock onto the bars on both
sides of the seat.
Reconnect the seat pad
to the front of the child
restraint.
Using your full weight, push
the child restraint firmly into
the vehicle seat while pulling
up on the Lower Anchor
Strap to tighten, as shown.
IMPORTANT: Make
sure both lower anchor
connectors are facing
upward and the straps
are not twisted.
PLACE
AT
ARMPIT
CLICK!
Restraints with Quick Connector™
Correct Incorrect
Quick Connector™
Rear-facing Installation with Lower
Anchor (UAS) Connectors
WARNING!
DEATH or SERIOUS
INJURY can occur.
* Guides not available on all models.
To Next Page
Loading...
