Need help?Do you have a question about the Evenheat RampMaster II and is the answer not in the manual?
Provides a step-by-step guide for quick programming using the Cone Fire Mode.
Offers a quick guide to programming custom firing cycles using the Ramp Mode.
Describes the physical layout and primary functions of the RampMaster II control panel.
Provides detailed explanations for each key and its operation on the RampMaster II.
Explains the different pre-set Cone Fire modes available for ceramic firing.
Explains the concept of segments in creating custom firing programs.
Describes how to view real-time segment data while a firing is in progress.
Details features for skipping segments and temporarily suspending a firing.
Covers boot-up, storing, and recalling Ramp Mode programs.
Explains how to review programs before firing and use the delay start feature.
Details zone control capabilities for enhancing temperature uniformity.
Provides the cone temperature lookup table for programming.
Describes the pre-heat function and how to program up to 16 segments.
Explains how to enable and disable the 16-segment programming feature.
Covers changing temperature scale and enabling/disabling error code functions.
Provides information on the Percent 4 feature and viewing the control board temperature.
Explains various ways the RampMaster II display indicates status and information.
A list of all display messages and their corresponding page numbers for reference.
Summarizes key functions based on the controller's current operating state.
Continues the summary of key functions for specific modes and presets.
Details interaction for viewing segments, reviewing programs, and cone table lookups.
Explains the operation of numerical keys and the Enter key.
Provides detailed firing parameters for the preset Cone Fire Modes.
Lists and explains various error codes generated by the RampMaster II.
Provides further details and causes for specific error messages.
Offers solutions for common kiln problems like failed elements or relays.
General| Number of Programs | 8 |
|---|---|
| Number of Segments per Program | 8 |
| Output Type | Relay |
| Memory | Non-volatile |
| Input Voltage | 120V or 240V |
| Controller Type | Ramp/Soak |
| Control Accuracy | ±1°F |
| Input Type | Thermocouple Type K |
| Display | Digital |
| Programmability | Fully programmable |
To Next Page
