Eventide TimeFactor - Page 15

TimeFactor User Guide SpillOver
15
SpillOver
SpillOver provides smooth transitions when changing Presets by fading the lingering echoes
of one Preset into the echoes of the next Preset.
SpillOver [SPILL] can be turned ON or OFF from the Utility section of the System menu.
Default is OFF. Here’s how to change this:
1) Press and hold the Encoder and Right Footswitch simultaneously for a few seconds
to enter System Mode. Release the Encoder.
2) Turn the Encoder until [UTILITY] is displayed.
3) Momentarily press the Encoder.
4) Turn the Encoder until [SPILL] is displayed.
5) Momentarily press the Encoder.
6) Turn the Encoder to select [ON] or [OFF].
7) Press and hold the Encoder and Right Footswitch simultaneously for a few seconds
to exit System Mode.