STYLE, GRILLED TO PERFECTION
TROUBLESHOOTING
Burner will not ignite when using the igniter:
Cylinder valve is not on Turn cylinder valve on.
Cylinder is empty Replace with a full cylinder.
Igniter button is not working Check battery.
Igniter is not sparking Remove plate and visually check ignition box for a spark. Check that
the cable is not broken or disconnected. Also check the alignment of
the sparker. If there is no spark, contact Everdure Service.
Injector is blocked Clean injector with a toothbrush. Do not drill out or use wire. Do not
remove injector. Contact Everdure Service.
Burner will ignite but won’t stay on:
Thermocouple not getting hot
enough
Hold the control knob in for 10 seconds after the burner ignites to
allow the flame safeguard to work.
Flame not reaching
thermocouple
Remove cooking surface & check flame after ignition. Could be due to
blockage in burner (clean burner) or strong winds.
Flame safeguards not working
Check thermocouple is in flame. Contact Everdure Service.
Burner flame is erratic:
Burner is blocked Remove burner and check for obstruction.
Flame is burning inside
burner (hissing sound)
Turn off burner, allow to cool and re-ignite (page 8).
Regulator is faulty Contact Everdure Service.
Injector is partially blocked Clean injector with a toothbrush. Do not drill out or use wire. Do not
remove injector. Contact Everdure Service.
Gas is leaking from connections:
Connections are loose Tighten loose connections (do not over-tighten) and leak test under
pressure with soapy water solution (page 5).
Hose has deteriorated Replace hose (Contact Everdure Service).
Gas valve is faulty Contact Everdure Service.
Threads are damaged Contact Everdure Service.
Lights not working:
Power not on Check that the power cord from the power adaptor is connected correctly
and that the power is on at the main power board.
Transformer overheated Turn off main power for half an hour before re-trying.
Globe(s) broken Replace globes.
Contact Everdure Service.
To Next Page
Loading...
