36
ABF 05-10-15
ENGLISH
START ON
When the label is fed it , performs a lamp-test turning on all the led’s and display for five seconds, once departed, turns
back in the same state in which was found’ it before interrupt the power supply .
If, there was a cycle in progress before the power down, at the turn on, the cycle departs in the same point in which was
interrupted and the display DIS1 visualizes the label “RES” flashing, to point out that a lack of tension is verified.
If before the lack of tension there was no cycle in progress, the display DIS1 visualizes the temperature of the probe
could room, and the display DIS2 shows up three hyphens. In this case the label is in STANDBY and is possible proceed
to another selection and start execution.
WITH SCHEDULE IN OFF:
the display DIS1 visualizes the label “OFF”, while the display DIS2 and all the led’s are turn it off.
Press the key on/off to the standby
If pressed for five seconds the key HACCP allows the visualization of the historic alarm list.
Press for five seconds, the key TIME
to set up time and date.
WITH LABEL IN STAND BY:
If pressed keys:
Blast chillers, temporized freezing , temperature freezing or Hard, allows the selection of one of the those cycles.
Press STERILIZATION key
, to start the cycle.
Press DEFROSTING key
to activate a defrosting cycle
Press for five seconds the key Temperature freezing, to start a cycle of heating core probe.
POINT UP TIME AND DATE
With label in OFF press for five seconds the key time
the display group shows up the following picture:
To Next Page
Loading...
