41
ABF 05-10-15
ENGLISH
When the temperature of core probe reaches the value defined for a temperature cycle, or the time planned expires ,
the blast cycle end’s, the buzzer plays and starts the phase of maintenance.
To switch of the buzzer press the key less
(decrease).
During the phase of maintenance the pressure of the key less
(Decrement) allows the visualization of the general
duration of the blast phase.
To visualize the temperature of the core probe, press key “temperature”
, the visualization remains on the displays
for five seconds.
NOTE: If the temperature of the core probe doesn’t reach the set point within the defined time, the display DIS2 blinking,
the cycle continues up to the attainment of the set point however.
Freezing Cycle in Temperature or time modality.
The display DIS1 shows up the core probe temperature in case of temperature cycles, or the temperature of the probe
cold room in cycles set’ it in modality “time”.
The display DIS2 visualizes the time in decrement in both kinds, temperature or time cycles.
To temperature modality cycles, the decrease of the cycles starts only if the core probe temperature is under the value
set’ it.
The led time
or temperature
frizzing turned on.
The pressure of the key Decrement
allows to visualize on the DIS2 , the time used since the beginning of the
freezing phase.
During a temperature cycle is possible view the core probe temperature cold room, press of the key freezing time
or temperature
.
The visualization remains on the displays for five seconds.
When the temperature of the core probe reach the value set’ it for a temperature cycle or expires the time set for a time
cycle, the blast negative cycle ends, the buzzer plays and it starts the maintenance phases.
To switch of the buzzer press the key less
(decrease).
During the maintenance phases, press the key Less
(decrease) allows the viewer of the all complete during of
the freezing phases.
During a temperature cycle is possible view the core probe temperature cold room by the press of the key Freezing
time or temperature.
the values are available on the displays for five seconds.
NOTE: if the probe core don’t reach the set point within the defined time, the display DIS2 blinks on, and the cycle con-
tinues until the set point reach.
To Next Page
Loading...
