www.evofitness.net.au
16
more strain on our leg muscles and may mean you cannot train for as long as you would like. If you are
also trying to improve your fitness you need to alter your training program. You should train as normal
during the warm up and cool down phases, but towards the end of the exercise phase you should
increase resistance, making your legs work harden than normal. You may have to reduce your speed to
keep your heart rate in the target zone.
The important factor here is the amount of effort you put in. The harder and longer you work the more
calories you will burn. Effectively this is the same as if you were training to improve your fitness, the
difference is the goal.
MAINTENANCE INSTRUCTIONS
WALKING BELT CENTERING AND TENSION ADJUSTMENT
DO NOT OVERTIGHTEN the walking belt. This may cause reduced motor performance and excessive
roller wears.
TO CENTER WALKING BELT:
● Place treadmill on a level surface
● Run treadmill at approximately 5KPH
● If the belt has drifted to the right, turn the right adjusting bolt 1/2 turn clockwise and the left adjusting
bolt 1/2 turn counterclockwise See pic A
● If the belt has drifted to the left, turn the left adjusting bolt 1/2 turn clockwise and the right adjusting bolt
1/2 turn clockwise and the right adjusting bolt 1/2 turn counterclockwise See pic B
Picture A If the belts have drifted to the LEFT Picture B If the belts have drifted to the RIGHT
WARNING: ALWAYS UNPLUG THE TREADMILL FROM THE ELECTRICAL OUTLET BEFORE
CLEANING OR SERVICING THE UNIT CLEANING
General cleaning or servicing the unit will greatly prolong the treadmill. Keep treadmill clean by dusting
regularly. Be sure to clean the exposed part of the deck on either side of the walking belt and also the
side rails. This reduces the build up of foreign material underneath the walking belt.
The top of the belt may be cleaned with a wet, soapy cloth. Be careful to keep liquid away from inside the
PIC A
PIC B
To Next Page
Loading...
