Evolis Tattoo 2 - Appendix C: Encoding Options; Magnetic Strip Encoding; Magnetic Encoder Location

Appendix C
C1 - Encoding options
Some models of Evolis printers are equipped with encoding systems which are used to customise magnetic strips, and contact and
contactless smartcards.
Depending on the model, it is possible to install up to three types of encoder in the printer (magnetic strip, contact and contactless
smartcards).
C1a - MAGNETIC STRIP ENCODING

strips in a single pass then runs a data check.

however shipped with a default setting of high coercivity (HiCo), unless otherwise requested when placing the order.
³
Location of the magnetic encoder

taken by the cards and after the print head. The encoding sequence for a card is always carried out
before the printing.
Use only magnetic strip cards that comply with ISO 7810 and ISO 7811 standards.
The magnetic strip must be moulded into the card to work properly.
Never use cards with a glued-on magnetic strip.
C
45