Evolution hulk petrol - Pre - Operating Checks; Starting the Hulk Engine

17
www.evolutionpowertools.com
• RemovetheOilFiller/LevelCapandwipethe
dipstick with a clean dry cloth.
• Pourintherequiredamountofoil.(approx0.25L)
• Allowtheoiltosettlefor10+seconds.
• Viewtheoillevelthroughtheoilllerorice.The
oil level should be very near the top of the threads
with oil just about to spill out from the crankcase
(the machine must be on a level horizontal surface).
• Insertthedipstickandscrewthecapfully‘home’.
Unscrew the filler cap and withdraw the dipstick.
Visually check the
oil level on the dipstick.
• Adjustasnecessary.
• WhentheleveliscorrecttightentheOilFiller/Level
Cap securely into the engine casing.
Note: Change the oil according to the Maintenance
Summary Chart (Refer also to MAINTENANCE –
Engine oil replacement)
Pre – operating checks
Note: Before each operation the machine should be
inspected to ensure that all safety features etc, are
working correctly.
• Checkthatallsafetyguardsareinpositionand
undamaged.
• HulkElectro–Checktheintegrityofthepower
cable and plug. If the power cable or plug is
damaged in any way the cable and/or the plug
must be replaced by a competent technician with
identical replacement parts.
• HulkPetrol-Checkallfuelhoses,unionsandller
caps etc for signs of fluid leakage. Any leak detected
must be repaired before operations commence.
• Checktheengineoillevelandadjustasnecessary.
• Checkthefuellevelandtopupasnecessary.
• Thoroughlyinspecttherestofthemachinefor
any form of damage particularly to covers, guards,
rubber components etc.
Starting the Hulk Engine
• Turnthefueltaplevertothe‘On’position.(Fig. 4)
• Setthechokelevertothe‘ChokeOn’position.
(Fig. 5)
Fig. 4
Fig. 5