34
www.evolutionpowertools.com
MAINTENANCE
Note: Any maintenance must be carried
out with the machine switched off and
disconnected from the mains/battery
power supply.
Check that all safety features and guards
operating correctly on a regular basis.
Only use this machine if all guards/safety
features are fully operational.
All motor bearings in this machine are
lubricated for life. No further lubrication
is required.
Use a clean, slightly damp cloth to clean
the plastic parts of the machine. Do not use
solvents or similar products which could
damage the plastic parts.
WARNING: Do not attempt to clean by
inserting pointed objects through openings
in the machines casings etc.
The machines air vents should be cleaned
using compressed dry air.
Excessive sparking may indicate the presence
of dirt in the motor or worn out carbon
brushes. If this is suspected have the machine
serviced and the brushes replaced by a
qualified technician.
(6.4) ENVIRONMENTAL PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
To Next Page
Loading...
