85
system. Both modes provide an entry delay time that allows you
to re-enter the premises without triggering an alarm.
Zones:
Assigning sensors to "zones". For example, a sensor on the
entrance/exit door can be assigned to zone 01, a sensor on the
windows in the master bedroom to zone 02, etc. These numbers
will appear on the display when an alarm or fault occurs.
Entry/Exit Delay:
Your security system has been programmed with a time delay that
allows you to leave the premises when the alarm is activated and
deactivate the system upon entry before the alarm occurs. If you
leave the premises too late or arm the system too late when you
get home, a false alarm will occur. If an alarm occurs, you should
deactivate the system immediately.
Alarms:
The security system will generate an "Open Door/Window" alarm
and display "Open Door/Window" when you leave the premises
and forget to close the door or window after the exit delay, an
alarm will occur and both the built-in and external audible signal
will sound.
Until the system is armed or the alarm bell timeout expires and a
message appears on the display identifying the zone(s) causing
the alarm. Your system can also be programmed to automatically
send alarm messages and voice messages over the mobile
network/GSM/GPRS/3G and send alarm notifications to the
mobile app. In addition, if your system is connected to a central
monitoring station, an alarm message will be sent. To stop the
alarm signal, simply deactivate the system.
To Next Page
Loading...