100
WIRELESS SENSORS
Pairing a new sensor
Select "Main
menu → Parts → Detector → Add".
Use to navigate to , then use to navigate to the desired
zone name.
Use to navigate to , then use to navigate to the desired
zone mode (type).
Each zone (sensor) needs to be assigned a zone type that
determines how the system responds to faults in that zone.
"Stay Arm Active" is usually assigned to sensors or contacts on
entry and exit doors, exterior doors and windows, and perimeter.
Active in AWAY or STAY mode.
"Out Arm Active" usually refers to an indoor space (e.g. a hall or
room). It is bypassed automatically when in STAY mode.
"24 hours active" is usually assigned to the zone containing the
panic button, smoke button and emergency button. CO, water
and gas leak sensors.
To use it as a doorbell, select "Doorbell".
To turn off the zone, select "Close".
Use to go to , then use the numeric keypad to enter th
e
zo
ne number (values 0-89 are available). The zone number should
be unique.
Press the button , the "Synchronizing" message will appe
ar
o
n the display, the system will enter pairing mode and coun
t
d
own the remaining time until pairing.
To Next Page
Loading...