99
Press to save the new settings.
WIRELESS KEYS
Pairing a new wireless controller
Select "Main menu → Parts → Remote control → Add".
The display shows "Synchronising", the system enters pairing
mode and counts down the remaining pairing time.
Press one wireless control button to send a transmission signal
to the panel.
After adding the serial number of the wireless controller to th
e
p
anel, the message "Learning OK" will be displayed.
If the serial number of the wireless controller has been detected,
the system will display "Device code detected".
Remove
Select "Main menu → Parts → Remote control → Delete".
Use th
e b
uttons to navigate to the serial number you want
to delete.
Press to delete the selected serial number.
Delete all
Select "Main menu → Parts → Remote control → Delete all".
The total number of serial numbers learned is displayed.
To delete all serial numbers, press .
To Next Page
Loading...