101
The sensor sends a transmission signal to the panel.
After adding the serial number of the wireless sensor to th
e
p
anel, the message "Learning OK" is displayed. If the se
rial
number of the wireless sensor has been detected, the display will
show "Device code detected" and the zone name/mode/number
will be reset.
EDIT/REMOVE
Select "Main menu → Parts → Detector → Edit".
Use th
e b
uttons to navigate to the serial number you are
editing.
To edit the name/mode/number of the displayed zone, press .
To delete the selected serial number, press .
SAVE EVERYTHING
Select "Main menu → Parts → Detector → Delete all".
The total number of serial numbers learned is displayed.
To delete all serial numbers, press .
INSTALLATION
Motion detector
1.
M
ount the detector on the mounting bracket and then adjus
t
the height and angle. The recommended height is 2.2 m above the
ground.
To Next Page
Loading...