page 11 of 49
INSTALLATION GUIDE
1. Before installation: Pre-requisites
1.1. Safety and precautions
Intended use: This product is solely designed and approved for use as an Electric Vehicle Supply
Equipment (EVSE), used to supply charging current to EVs and PHEVs that do not require
ventilation. It is intended to be used within specifications and only with the appropriate auxiliary
equipment and adequate wiring. It is not intended to be repurposed or reconfigured for any
application or use not within its specification. Failure to operate the device as intended may
result in severe damage to equipment and personnel and poses a fire and explosion hazard.
Risk of electric shock: This device utilizes voltages that pose an immediate threat to life. It shall
be installed only by a licensed or experienced electrician. The device and auxiliary equipment
shall be carefully inspected for signs of damage (cracked case, frayed or exposed conductors,
and compromised insulation) before installation or use. Any installation or servicing activities
shall be executed only after the mains supply has been disconnected from the main breaker or
by physically disconnecting the supply conductors at the main distribution board.
This device is intended to be connected to a centrally grounded system. The PE conductor shall
be adequately sized and grounded to earth at the service equipment. The EVSE has a built-in
RCD, which protects the downstream conductors from earth leakage events. To protect
upstream conductors, an RCD Type A– AC: 30mA/ DC: 6mA must be used at the supply
equipment.
Risk of fire or explosion: This device handles high voltages and currents. Use of improperly rated
conductors can result in excessive heating, leading to a risk of fire and damage to the mechanical
integrity of the system. AC grid connection shall be made in accordance with the device
technical requirements to ensure that the installation is sufficient to supply the rated maximum
current and power. The product uses relays, which can cause arcs during switching. The device
shall be installed in a location free from flammable gases and liquids to avoid an explosion
hazard.
Mechanical: The product is intended for wall or panel mounting. It shall not be installed on
ceilings, floors, or inclined walls. To avoid mechanical damage, the product shall be mounted as
described in the installation guide, and using the specified tools and materials.
Proper Personal Protective Equipment is recommended, including but not limited to: eye
protection, electrical shock protection, gloves, and other appropriate protection.
To Next Page
Loading...