EVPoint EV22 Series - 6 Appendix II: OCPP and Manufacturer Configuration Keys

page 45 of 49
6. Appendix II: OCPP and Manufacturer Configuration
Keys
Configuration Key
Custom
Key
In use
Example Value
Description
AllowOfflineTxForUnknownId
yes
TRUE
When offline, the device can
be set to allow automatic
authorization of any
"unknown" identifiers that
cannot be explicitly
authorized by Local
Authorization List or
Authorization Cache entries.
AuthorizationEnabled
TRUE
AuthorizeRemoteTxRequests
TRUE
ChargeProfileMaxStackLevel
100
ChargingScheduleAllowed
ChargingRateUnit
yes
A,W
Configures the units of
"charge power" to be used
in a charging schedule.
ChargingScheduleMaxPeriods
60
ClockAlignedDataInterval
0
ConnectionTimeOut
90
Interval of time from status
“Preparing” until the
transaction is automatically
canceled, due to failure of
the EV driver to insert the
charging cable into the
charger or vehicle. The
charger will revert to the
original state.
ConnectorSwitch3to1PhaseSupported
FALSE
Configures the three phase
chargers to work on a
single-phase grid as single-
phase charger.
c_ChargingVentilatedEnabled
yes
yes
FALSE
Allows the charger to offer
charge when the vehicle
enters in state "D"
c_DeviceLimit_I
yes
yes
320
Sets a hard limit on the
maximum current the device
will offer in 1/10ths of an
ampere. The limit cannot be
overridden by profiles.
c_MainFuseLimit
yes
yes
600
CT clamp current limit, fuse
set in 1/10ths of an ampere
c_RCDProtectionType
yes
yes
0
Configures RCD protection
type. Permitted states:
0 - Both AC + DC protection
is on
2 - Only AC protection is on
c_VoltageProtectionOffset
yes
yes
0
Enables configuration of
expanded voltage
protection limits. The
default range with the key