EVS XT[2] - Hot Swap

To Next Page

To Previous Page

Issue

10.03.B

XT Series DISK RECORDER

–

Version 10.03 - Hardware Technical Reference

EVS Broadcast Equipment SA

–

July 2010

Class of equipment: Class 1 equipment (EN60950 § 1.2.5): electric shock

protection by basic insulation and protective earth.

Rated voltage: 110 to 240Vac (single phase)

Rated frequency: 50-60 Hz

Related Current: 10 A (100 to 120 Vac range) 5 A (220 to 240 Vac range)

Input connector: CEE22/IEC 320 3-pin male receptacle

Environmental Conditions

The equipment should be kept in the following environmental conditions:

Temperature: 0°C to +40°C (32°F to 104°F) ambient with free air flow

Relative humidity: 0% to 90% (non-condensing)

Cooling requirements: Forced air cooling air flow from front to back

Handling/movement: Designed for fixed use when in operation

Storage and transportation temperature: 0°C to +70°C (32°F to 158°F)

Storage and transportation relative humidity: 0% to 90% (non-condensing)

HOT SWAP

This equipment is equipped with AUTOSWITCH and hot-swappable power supply.

Connection to supply: Pluggable equipment Type A (EN60950 §1.2.5): Equipment

which is intended for connection to the building power supply wiring via a non-

industrial plug and socket-outlet or a non-industrial appliance coupler or both.

Correct mains polarity must always be observed. Do not use reversible power

plugs with this equipment.

Class of equipment: Class 1 equipment (EN60950 § 1.2.5): electric shock

protection by basic insulation and protective earth.

Rated voltage: 115 to 240Vac (single phase)

Rated frequency: 47-63 Hz

Related Current: 8 A (100 to 120 Vac range) 4 A (220 to 240 Vac range)