How to fix network startup issues on EVS XT-3 Server?
If the network does not start up properly, even with correct configurations and Multicam started, verify that the cables connecting all EVS servers are suitable and not excessively long for operation.
What to do if connection cannot be established on EVS XT-3?
If the connection cannot be established, ensure that all equipment is set to the same speed and connected to the non-relay connectors.
How to fix EVS XT-3 when the network does not start up properly?
If the network on the EVS server does not start up properly, check that selected cables to connect all EVS servers are suitable and not too long to operate.
Safety requirements and standards the equipment meets.
Electromagnetic Compatibility (EMC) standards the equipment complies with.
Physical dimensions and weight of XT3 server models.
Details on the redundant power supply and electrical specifications.
Video standards and formats supported by the XT3 server.
Audio configurations and specifications for XT3 servers.
Detailed description of the XT3 server rear panel connectors.
Overview of board placement and configurations in XT3 racks.
Description of the V3X video and reference boards.
General| Power Supply | Dual redundant power supplies |
|---|---|
| Processor | Intel Xeon |
| RAID Support | RAID 0, 1, 5, 6, 10 |
| Recording Format | ProRes, DNxHD |
| Control Interface | Ethernet |
| Network Connectivity | 10Gb Ethernet |
| Video Format | HD |
| Networking | Ethernet |
| Memory | 32GB |
| Storage | SSD |
| Operating System | Linux |
| Form Factor | Rackmount |
To Next Page
![Preview: EVS XT[2]](https://data.easymanua.ls/products/617905/200x200/evs-xt-2.webp)
