EVS XT-3 User Manual

6.7. MTPC Board
Introduction
The function of the PC board is mainly the control of the video hardware and the interface
of the peripheral equipment (such as a remote controller) with the video hardware.
The following MTPC board is used:
• Revision A3/A6 with COMMEL HS873 motherboard and a new time code
management module (with bootable USB).
In standard configuration the PC hardware is composed of:
• One mounting PC board, with serial ports, LTC reader and generator, is controlled by
the motherboard.
• SAS System Hard disk: the SAS disk drive is used for storing the EVS software and
the DOS operating system. Neither audio nor video data is saved on this disk. The
capacity of this drive may vary depending on market availability, but the system
partition is always set to 2GB. The remaining capacity of this drive is not used.
• 256 MB SDRAM (or higher) to suit the system requirements from Multicam 12.00.
Please contact EVS support for RAMs upgrade. Do not use standard PC RAM
modules.
HARDWARE TECHNICAL REFERENCE MANUAL XT3 Server 12.05
6. Boards Description 111

EVS XT-3 Specifications

General

Brand	EVS
Model	XT-3
Category	Server
Language	English