Exalto Wiper Technologies type CT3N - 3
1. General
1.1 General description
CT3N is an electronic wiper control system for up to ve motors. CT3N is composed
by one control panel and one relay box. The control panel and the relay box are con-
nected by an CAT5 cable (CAN Bus cable).
• Double voltage supply: 12V - 24V
• Activates/deactivates each wiper one by one
• 2 continuous speeds (Slow/Fast)
• Three intermittent settings
• Synchronization in every mode
• Self parking due to dynamic brake
• Wipe/wash program
• Single wipe function
• Heater activation (additional relay box required)
• Selection of backlighting color and dimming facility
• Fault and error signaling
1.2 Standard supply
• 1 x Control panel
• 1 x Relay box
• 1 x 5 meter cable or CAN Bus connection
• 1 x 4-poles female connector for Relay box to motors connection
(1 for each motor)
• 1 x female 6,3mm fast-on terminal for washing pump connection
• 2 x (or 4 if more than 3 wipers) female 9,5mm fast-on terminal for power supply
connection
To Next Page
Loading...