19
TROUBLESHOOTING
PROBLEM SOLUTION
There is no display on the computer
console.
1. Remove the Computer (32) and verify the
wire that comes from the Computer (32) is
properly connected to the wire that comes
from the Main Frame (1).
2. Check if the batteries are correctly
positioned and battery springs are in proper
contact with batteries.
3. The batteries in the computer console may
be dead. Change to new batteries.
The elliptical trainer makes a squeaking
noise when in use.
The bolts may be loose on the elliptical trainer,
please inspect the bolts and tighten the loose
bolts.
Tension adjustment doesn't work.
Undo the buckle of the plastic clip and pull the
top strap to re-tighten the tension belt.
Clicking Noise.
After long use, the chain may get loose and
start to have clicking noise. You may open
the Right Cover (35R) to reach the Nut M6
(46). Tighten the chain by screwing the
Nut M6 (46) clockwise.
The elliptical is not sturdy enough.
Make sure the middle knobs touch the ground
and the elliptical is leveled by turning the Rear
Stabilizer End Cap (39). Please refer to page
19.
To Next Page
Loading...
