EXFO FPM-300 - Introduction to EXFO FPM;FLS;FOT Series; Main Features Overview

Introducing the FPM-300/FLS-300/FOT-300 1
1 Introducing the
FPM-300/FLS-300/FOT-300
This user guide covers the following products (unless otherwise specified,
descriptions apply to all):
 FPM-300 Power Meter
 FLS-300 Light Source
 FOT-300 Optical Loss Test Set: combines both a power meter and a light source
Main Features
FPM FLS FOT
Ge or GeX detector with 10 calibrated wavelengths X X
Absolute power and link loss measurements X X
Editable list of favorite power meter wavelengths X X
Editable list of favorite source wavelengths X
Automatic wavelength detection X X
No offset nulling of detectors required in normal operation X X
Multiple source configurations on a single port [FOT-300] or
on one or two ports [FLS-300]
XX
Transmission of editable power value with source’s signal for
automatic reference with compatible power meter
XX
Transmission of wavelength to compatible power meter in
automatic wavelength or auto-switching mode
XX
Modulated signal emission or detection (270 Hz, 1 kHz and
2 kHz) compatible with other EXFO units
XXX
Automatic shutdown after 10 minutes of idle time (auto-off) X X X