Using Your Unit
Attaching Modules
1
WARNING
To avoid electrical shock, always shut down the unit, and
disconnect it from its external power source BEFORE removing a
module.
Never remove a module while the unit is turned on. This will result
in immediate and irreparable damage to both the module and unit.
2
Place the front panel on the module making sure that the mating connector of the module is well
aligned with the corresponding slot on the front panel.
Using a flat screwdriver, turn the screws clockwise
until they are tightened.
To adjust brightness
Information about the connected module
To start the applications related to the module
To retrieve information about your unit
To view the online help
Keyboard/screen capture button
Press once to show the on-screen keyboard.
Press once again to hide it.
Hold down for a few seconds to take a screen
capture.
Task-switching button
Press once to view the list of running applications.
Press as many times as needed to select the desired
application.
On/Off button
Press to turn the unit on.
Press to shut down the unit (default
behavior).
Button bar
To access modules and instruments, test
tools, utilities, documentation, and
to configure your unit
Mating connector
Connection slot for the module
3
While holding the front panel and the module firmly together, turn the unit over, and position it so that
its front panel rests on a flat surface such as a table.
Position the module so that its back panel rests on a flat surface such as a table.
The battery should be visible.
4
To Previous Page
Loading...
Need help?
General
