Exmark Turf ranger User Manual

- 20 -
d) If the oil level is low, fill to the “FULL” mark on the dipstick. Use oil as
specified in Engine Owner’s Manual. Do Not overfill.
IMPORTANT: Do not operate the engine with the oil level below the “LOW” (or
“ADD”) mark on the dipstick, or over the “FULL” mark.
6.1.2 Clean engine air cooling system:
Service Interval: See Engine Owner's Manual
CAUTION
POTENTIAL HAZARD
♦ Excessive debris can cause the engine and hydraulic
system to overheat.
WHAT CAN HAPPEN
♦ Excessive debris around the engine and inside the
transmission cooling compartment can create a fire
hazard.
HOW TO AVOID THE HAZARD
♦ Clean all debris from around the engine and
transmission daily.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Clean all debris from engine air intake screen and from around engine
shrouding.
6.1.3 Clean transmission cooling compartment:
Service Interval: Daily
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Clean all debris from screens that encompass cooling compartment, and
then remove the compartment screen.
c) Clean all debris from the fan blades and the cooling fins for the
transmission.
d) Replace the compartment screen.
6.1.4 Clean grass build-up under mower deck and check mower blades.
Service Interval: Daily
CAUTION
POTENTIAL HAZARD
♦ Raising the mower deck for service or maintenance
relying solely on mechanical or hydraulic jacks could
be dangerous.
WHAT CAN HAPPEN
♦ The mechanical or hydraulic jacks may not be enough
support or may misfunction allowing the unit to fall,
which could cause injury.
HOW TO AVOID THE HAZARD
♦ DO NOT rely solely on mechanical or hydraulic jacks
for support. Use adequate jack stands or equivalent
support.
a) Disengage PTO.
b) Raise deck using lift actuator.
c) Stop engine, wait for all moving parts to stop, and remove key.

Exmark Turf ranger Specifications

General

Brand	Exmark
Model	Turf ranger
Category	Lawn Mower
Language	English