Exor ePALM10 - Programming connector

Tech-note
tn202-2.doc - 10.01.2012
ePALM10 Product Manual
22
Termination
Setting
Switch Position
Open (not used) Off
On
(Default)
Figure 13 – Termination resistors
4.3.2 Programming connector
On the back of the ePALM a RS-232 serial port is available for programming the device; the drawing
below shows the position and the pin-out of the connector.
1
7
Figure 14 – Programming connector
Pin
Signal
1 NC
2 +5VDC out
3 RX
4 TX
5 RTS
6 CTS
7 GND
Use cable CA234 to connect the ePALM to a Personal Computer for programming. The cable
diagram is shown in the figure below.