GENERAL SETUP PROCEDURES
23
CHAPTER 6 : General Setup Procedures
6.1 Password Setting
Press and hold the SETUP key while power on the instrument, the program will
enter the Password setting mode. The display will show:
Password = 0
Range : 0 - 9 9 9 9
or Password = X X X X
Range : 0 - 9 9 9 9
The Password can be any four (4) digit number. If the Password is set to 0, the
keyboard lock out will be selected by the LOCK key on the front panel without a
Password. The Password default is preset to 0 at the factory. The password will be
saved automatically when the ENTER key is pressed and the instrument will return
to normal operation.
6.2
Key Lock
Press the LOCK key. If the Password is Enabled, the display will show:
Password = _
Range : 0 - 9 9 9 9
Use the Numeric Keys to enter the password and then press the ENTER key. The
program will switch the Key Lock function from LOCK to UNLOCK or UNLOCK
to LOCK mode and advance the program to operation mode automatically. If the
wrong password is entered, the program will give a warning beep and the display
will momentarily show ERROR and then return to the previous screen to allow a
new password entry.
Password = ERROR
Range : 0 - 9 9 9 9
Press the EXIT key to return to the operation mode.
If the Password is Disabled (Password is set 0), the display will show:
Key Lock = O N
ENTER to select
or Key Lock = O F F
ENTER to select
Use the ENTER key to select the Key Lock mode, then press the EXIT key. The
program will switch the Key Lock function from LOCK to UNLOCK or UNLOCK
to LOCK mode and advance the program to the operation mode automatically.
To Next Page
Loading...