Hardware Installation
AP-8533 Access Point Installation Guide 15
The Access Point is ready to configure.
Suspended Ceiling T-Bar Mount Instructions
Ceiling mount requires holding the AP-8533 up against the T-bar of a suspended ceiling
grid and twisting the unit on to the T-bar. If deploying the AP-8533 on a sculpted ceiling T-
Bar, the Access Point mounting kit (Part No. KT-135628-01) can optionally be used as well.
CAUTION
If not using an AP-PSBIAS-2P3-ATR Power Injector, ensure only the AP-8533’s
designated power supply (PWR-BGA48V45W0WW) is used to supply power
to the Access Point. Using an incorrectly rated power supply could damage the
Access Point and void the product warranty. Do not actually connect to the
power source until the cabling portion of the installation is complete.
To Next Page
Loading...
