Floor Plans on page 16
Site Location on page 67
Device Groups on page 12
RADIUS Configuration for Switches Per Site on page 66
SNMP Configuration on page 199
NEW!
RADIUS Configuration for Switches Per Site
ExtremeCloud Appliance supports direct access from a switch to an external RADIUS server within the
site configuration. You can associate up to two RADIUS servers for accounting and two RADIUS servers
for authentication.
Note
When using 200 Series switches, only one accounting server is supported.
You must first configure the RADIUS servers before you can associate them to switches in a site
configuration.
1 Configure each RADIUS server.
Go to Onboard > AAA > RADIUS Servers.
2 Associate the RADIUS servers to the switches within the site configuration.
a Go to Configure > Sites and select a site.
b Select the Switches tab.
c Configure the following parameters:
RADIUS Authentication
Servers
Up to two RADIUS servers configured for authentication. Click Add and select from
the list of IP Addresses.
Enable RADIUS
Accounting
Enable or Disable RADIUS Accounting. Select Enable to enable RADIUS Accounting.
When RADIUS Accounting is enabled, all switches in the site receive the RADIUS
Accounting server definition.
RADIUS Accounting
Servers
Up to two RADIUS servers configured for accounting. Click Add and select from the
list of IP Addresses. When using 200 Series switches, only one accounting server is
supported.
Switches Check the switches that are associated with the site.
Related Links
Managing RADIUS Servers on page 146
Switch Port Configuration on page 116
MSTP on page 66
MSTP
Enable the MSTP (Multiple Spanning Tree Protocol) to optimize load balancing.
1 Go to Configure > Sites and select a site.
2 Select the Switches tab.
Configure
ExtremeCloud Appliance User Guide for version 4.36.03 66
To Next Page
Loading...
