Important
You must provide your own cable clamps if you are mounting the access point to a pole
that is less than 3 in. or more than 7 in. in diameter.
Tip
The best practice is to use a stainless-steel cable clamp that is 0.5 in. (12.7 mm) wide.
• A flat-head slotted screwdriver to tighten the clamp screws
About This Task
Install the access point on a vertical pole or a horizontal pole at outdoor environments. If you are resting
the access point under a horizontal pole, use this installation method only during indoor warehouse or
distribution center installations.
Caution
Do not install the access point in freezers.
Procedure
1. Thread the cable clamp straps through the access point rear slots.
2. Position and insert the cable clamp straps around the pole.
Note
Ensure that the access point top slots face the sky and the bottom slots face the ground.
Install the Access Point on a Vertical Pole or a
Horizontal Pole Install the Access Point
18 ExtremeWireless™ AP460C, AP460S6C, and AP460S12C Access Points
To Next Page
Loading...
Need help?
General
