Regulatory Information
Extreme Networks Wireless AP3825 Installation Guide
34
Extreme Networks Wireless WS-AP3825i and WS-
AP3825e
The following regulatory information applies to the Extreme Networks Wireless access
points WS-AP3825i and WS-AP3825e.
United States
FCC Declaration of Conformity Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
residential and business environment. This equipment generates, uses, and radiates radio
frequency energy, and if not installed and used in accordance with instructions, may cause
harmful interference. However, there is no guarantee that interference will not occur. If this
equipment does cause harmful interference, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the transmitting antenna.
• Increase the separation between the equipment or devices.
• Connect the equipment to an outlet other than the receiver's.
• Consult a dealer or an experienced radio/TV technician for suggestions.
USA Conformance Standards
This equipment meets the following conformance standards:
Safety
• UL 60950-1
EMC
• FCC CFR 47 Part 15, Class B
Radio transceiver
• CFR 47 Part 15.247, Subpart C
• CFR 47 Part 15.407, Subpart E
To Next Page
Loading...
