Chapter 3
3 - 2
Using the LCD panel
You can configure the LCD panel to meet your needs. The following section
describes how to perform a number of tasks with the LCD panel:
• Pause on a screen
• Access the LCD menus
• Power up the unit
• Halt the unit
• Power down the unit
• Reboot the unit
• Clear alerts
Pausing on a screen
Normally, the screens cycle on the LCD at a constant rate. However, you
can push the Check button to toggle the LCD between Hold and Rotate
modes. In Hold mode, a single screen is displayed. The Rotate mode
changes the screen displayed on the LCD every 4 seconds.
Accessing LCD menus
Press the X button to put the LCD panel in Menu mode so you can access
the menus. The buttons Left Arrow, Right Arrow, Up Arrow, and Down
Arrow are only functional when the LCD is in Menu mode. For more
information about using the LCD menus, see Navigating through the LCD
menus, on page 3-4.
Powering up the unit
When you want to power up a unit that is shut down, press the Check button
to turn the power on.
Halting the unit
We recommend you halt the unit before you power it down or reboot it
using the LCD menu options.
To halt the unit
1. Press the X button, then use the arrow keys to navigate to the
System menu.
2. Press the Check button. Navigate to the Halt menu.
To Next Page
Loading...