Operating the LCD Panel
Platform Guide: 8400 and 8800 3 - 3
3. Press the Check button. Press the Check button again at the
confirmation screen.
4. Wait 30 seconds before powering the machine off or rebooting it.
Powering down the unit
Hold the X button for 4 seconds to power down the unit. We recommend
that you halt the system before you power down the unit in this manner.
Halting the unit puts the chassis into a powered on, but quiet state where the
LCD has power and its keypad is dimly lit, but everything else is off. Simply
pressing the green Check button again powers the unit back on.
The system is designed to remember the state of the chassis soft power state
even when the AC power is removed, and to restore that state when AC
power is reapplied. If you power off the chassis using the Check button and
then disconnect the power cord, the power state of the chassis returns to the
soft powered off state when you reconnect the power cord.
Rebooting the unit
Hold the Check button for 4 seconds to reboot the unit. You should only use
this option after you halt the unit.
Clearing alerts
Press the Check button to clear any alerts on the LCD screen. You must
clear any alerts on the screen before you can use the LCD.
To Next Page
Loading...