FAAC 400 - 4 Start-Up; Anti-Crushing System Adjustments; 5 Final Operations

9
FAAC 400 Hydraulic Swing Gate Operator
4. START-UP
The Model 400 has an anti-crushing safety device which limits the
operator’s force when an obstacle is encountered while the gate
is moving. To adjust the intervention threshold of the anti-crushing
system, temporarily open the release cover.
• Lift the protective cap (Fig. 13, Ref.1) and insert the supplied
key (Fig. 13, Ref. 2).
• Turn the key 90°clockwise to open the cover.
• Lift the cover (Fig. 14).
• Remove the screw (Fig. 14, Ref. 3) which secures the knob
and then remove the knob (Fig. 14, Ref. 4).
• Locate the force adjustment screws (By-Pass) on the operator
(Fig. 14, Ref. 5 and 6) .
• OPEN pressure screw (green wording): gate opening
direction.
• CLOSE pressure screw (red wording): gate closing
direction.
• To reduce torque, turn screws counter-clockwise.
• To increase torque, turn screws clockwise.
• When you have nished making adjustments, re-position the
knob (Fig. 14, Ref. 4) and tighten the screw (Fig. 14, Ref. 3).
• Close the cover and lock it by turning the key counter-
clockwise.
Figure 11 Figure 13
Figure 12
Connect the power cable to the operator and fasten the
screws (Figure 14A).
5. FINAL OPERATIONS
Finish the installation procedure as follows:
• Close the cover of the release device with the key.
• Remove the vent screw (Fig.12, Ref. 2).
Figure 14
Figure 14A
Anti-Crushing System Adjustments
WARNING: Do not overtighten the screws to
compensate for a damaged gate.
WARNING: Failure to remove the vent screw may result in
erratic operation.