12
FAAC 400 Hydraulic Swing Gate Operator
Run a functional check of the system at least twice a year.
Pay special attention to the efciency of safety and release
devices (Including the thrust force of the operator), and the
perfect operation of the gate hinges.
Checking Oil Level:
Periodically check the oil level inside the tank.
• Cut power to the system.
• Position the operator vertically, with the rear ange high up.
• Remove the oil ll plug.
• Insert a screwdriver until it comes in contact with the electric
motor as shown in Fig. 18.
• Remove the screwdriver and check oil level as shown in Fig.
18.
• USE ONLY FAAC HP FLUID OIL
Periodically check for correct adjustment of the anti-crushing
safety device and the effectiveness of the release system to
allow manual operation.
Safety devices installed on the system must be checked
every 6 months.
For repairs, contact FAAC’s authorized repair centers.
Figure 18
11. MAINTENANCE AND REPAIRS
To Next Page
Loading...
