ENGLISH
4) Close the cover with the four supplied screws, Fig.16.
4.6. Mechanical travel stops
The 413 operators are equipped with opening and closing mechanical travel stops. They can be used instead of the leaf mechanical
limit stops. To adjust the mechanical travel stops operate as follows:
4.6.1. Adjusting the opening mechanical travel stop
1) Set the operator for manual operation, see paragraph 6
2) Manually move the leaf in opening position.
3) Loosen the fastening screw, Fig.17 ref.A. Do not remove the screw.
4) Move the stop near the fitting as shown in Fig.18.
IMPORTANT: The mechanical stop works coupled to a toothed sector, Fig. 17 ref. B. If there are any troubles during the
movement, make sure that the coupling is free. DO NOT FORCE.
5) Re-tighten the securing screw, checking correct coupling to the toothed sector.
4.6.2. Adjusting the closing mechanical travel stop
1) Set the operator for manual operation, see paragraph 6
2) Manually move the leaf in closing position.
3) Loosen the fastening screw, Fig.19 ref.A. Do not remove the screw.
4) Move the stop near the fitting as shown in Fig.20.
IMPORTANT: The mechanical stop works coupled to a toothed sector, Fig. 19 ref. B. If there are any troubles during the
movement, make sure that the coupling is free. DO NOT FORCE.
5) Re-tighten the securing screw, checking correct coupling to the toothed sector.
Fig. 18
Fig. 20
Fig. 16
Fig. 17
Fig. 19
To Next Page
Loading...
