FAAC 413 - Wiring the Operator

ENGLISH
5) Fix the operator to the rear bracket by means of the supplied pins as shown in
Fig.12.
6) Close the leaf and, keeping the operator in a perfect horizontal position, determine
the fastening point of the front bracket (Fig.13).
7) Temporarily fix the front bracket with two welding spots (Fig.13).
Note: if the gate structure does not allow a fix bracket fastening it is
necessary to create a sturdy supporting base in the gate structure.
8) Release the operator (see paragraph 6) and manually check if the gate can
completely open without hindrances and stop at the mechanical travel stops as
well as if the leaf moves regularly without any friction.
9) Carry out the necessary corrective measures and repeat from point 8.
10) Temporarily release the operator from the front bracket and weld the bracket
definitively.
Note:
• before securing the operator to the bracket you have just welded, wait
for it to cool.
• we recommend to grease all the fastening pins of the fittings.
4.5. Wiring the operator
A terminal board is fitted in the lower part of the operator for the connection of the motor, of any limit switch
and for the earthing of the operator.
IMPORTANT : To connect the motor, the supplied cable must be used for the mobile section, or
a cable for mobile laying from the outside.
Motor wiring operations:
1) Open one of the two pre-drilled holes in the supplied cover, Fig.14; in case of operators with limit switches,
open both holes.
2) Fit the supplied cable gland.
3) Connect the motor and the earthing with reference to Fig.15 and to the table.
To maintain approval for CSA-UL approved operators, position the capacitor (secured in a
stable manner) inside a CSA-UL approved enclosure.
Attention: before securing the operator to the bracket you have just
welded, wait for it to cool.
)~V511(~V032314
.SOP RUOLOC NOITPIRCSED
1 )etihW(eulBelbacnommoC
2 )deR(nworB1esahP
3 )kcalB(kcalB2esahP
T
neerG/wolleY
)neerG(
gnihtraE
cdV42314
.SOP RUOLOC NOITPIRCSED
1 eulB1esahP
2 desutoN/
3 nworB2esahP
T desutoN/
Fig. 13
Fig. 12
Fig. 14
Fig. 15
16