ENGLISH
4.4. Installing the operators
1) Fix the rear bracket in the position determined before. In the event of iron pillar carefully weld the bracket directly on the pillar
(Fig.6). In the event of masonry pillar, use the suitable plate (optional) for the fixing to screw (Fig.7) by making use of suitable
fastening systems. Then carefully weld the bracket to the plate.
During the fastening operations, check if the bracket is perfectly horizontal by means of a level.
2) Assemble the rear fitting to the operator as shown in Fig.8.
3) Check if the front fitting is in the correct position as shown in Fig.9 (with closing mechanical travel stop) or in Fig.10 (without closing
mechanical travel stop). If this is not the case, temporarily supply power to the operator to position the fitting.
ATTENTION: The operator can be moved by hand only if it is installed on the gate and in released position (see
paragraph 6).
4) Assemble the front bracket as shown in
Fig.11. A hexagonal seat is located in the
lower part of the fitting CH=5 (Fig.11 ref. A)
to make the assembling operations easier.
Fig. 8
Fig. 9 Fig. 10
Fig. 6
Fig. 7
Fig. 11
To Next Page
Loading...
