Input Voltage 115Vac (+10% -6%)
Power 300 W
Current 2.5 A
Thrust 674 lbf (300 daN)
Effective Rod Stroke 15.7 in (400 mm)
Rod Extension Speed 0.73 in /sec (1.85 cm/sec)
Min Leaf Length 7.5 ft (2.3 m)
Max Leaf Length 15 ft (4.6 m)
Max Leaf Weight 700 lb (318 Kg)
Ambient Temperature
4°F +131°F (-20 °C +55°C)
Operator Weight 17.6 lb (8 Kg)
Protection Class IP 54
415 OPERATOR
1. DESCRIPTION AND SPECIFICATION
1.1 Technical Specifications
1.2 Dimensions
1.3 Electrical Setup
Always separate low voltage wiring from AC power cables. Use
separate conduits to avoid electrical interference.
The installer is responsible for grounding the gate and operator
systems, for providing the main power breaker switch, and for
making sure that the entire gate system meets all applicable
electrical codes.
Make sure to locate all controls that operate the gate system
at least 6 ft away from any moving parts.
6
Fig. 2
4
1/8 5 7/8
37
The FAAC 415 is an automatic gate operator for swinging
gates. It is designed for residential applications and can ac-
commodate gate leafs up to 15 ft long. The self-contained
415 operator consists of an electric motor that drives a worm
screw housed in an aluminum casing.
The operator has built in limit switches, that can be used in
place of positive stops to limt the gate travel.
Built-in security and anti-crushing measures of the 415 Opera-
tor include reverse on contact and an electronic torque
adjustment to control the force transmitted to the gate leaf.
The 415 Operator is designed and manufactured to
automate vehicular swing gates. Do not use for any other
purpose.
Fig. 1
9
* Measurements in Inches
Fig. 3
1 Operator
2 Release Device
3 Rod
4 Front Bracket
5 Rear Bracket
6 Rear Fork
7 Long Pin
8 Terminal Block Cover
9 Short Pin
1 415 Operators Limit Switches
2 x AWG 14 3 x AWG 20
2 Control unit AWG 14 for AC power
3 TX Photocells AWG 20 (Max. length 100’)
4 RX Photocells AWG 20 (Max. length 100’)
5 Key operated push-button AWG 20
To Next Page
Loading...
