FAAC 415 - Page 8

2. Assemble and attach the rear fork to the operator (Fig. 8).
3. Disengage the operator’s manual release (see Par. 4).
4. Completely extend the rod until it reaches the limit stop
(Fig. 9, Ref. 1).
5. Re-lock the operator (see Par. 4.1).
6. Turn the rod one half revolution clockwise (Fig. 9, Ref. 2).
7. Assemble the front bracket as shown in Fig. 10.
8. Mount the operator to the rear bracket using the supplied
pin as shown in Fig. 11.
Warning: allow the bracket to cool down before fastening
the operator to it.
9. Close the leaf and, while keeping the operator perfectly
horizontal, determine the fastening point of the front
bracket (Fig.12).
10. Temporarily attach the front bracket with two tack welds
(Fig.12). Protect the piston during the welding.
NOTE: Make sure that the gate structure allows for a solid
fastening point for the front bracket.
8
Fig. 7
Fig. 6
Fig. 9
Fig. 11
Fig. 12
Fig. 8
Fig. 10