FAAC 770 - DESCRIPTION & SPECIFICATIONS; Technical Specifications; Electrical Setup Guide; Operator Dimensions

6
1 Support Box
2 Cover Fastening Holes
3 770 Operator
4 Gate Support Bracket
5 Locking Bracket
6 Release Device with Key
7 Operator Ground Connection
8 Articulate lever
9 Pinion
10 Hole for Power Cable
11 Hole for Drain Pipe
12 Operator Fastening Bolts
13 Lubrication Hole
Fig. 1
Fig. 2
1
2
3
4
5
8
6
7
9
10
11
12
13
 770 Operators
 Photocells
 Control Unit
 Pushbutton
 Receiver
Power Supply 24 Vdc
Power 70 W
Current 3 A
Maximum Torque 221 lbf.ft (300 Nm)
Temperature Range 4°F +131°F (-20 °C +55°C)
Use frequency 100%
Class of operation Residential
Angular speed 6°/sec
Operator Weight 26 lb (12 Kg)
Max Leaf Opening Angle 110° (140° and 180° with
optional kit)
Protection class IP 67
Operator dimensions 14 x 6 x 5.5 in
(360 x 150 x 140 mm)
Foundation box dimension See Fig. 3
Max Leaf Length 11.5 ft (3.5 m) - 110°
9.8 ft (3 m) - 180°
8.2 ft (2.5 m) - 140°
Max Leaf Weight 1100 lb (500 Kg)
2.1 Preliminary checks
To ensure a correctly operating automated system, the
structure of the existing gate or gate to be built must satisfy
the following requirements:
• Leaf dimensions are within the limits
• The gate swings level
• Smooth, uniform leaf movement, without any irregular
friction during the entire travel
• Existing hinges in good condition
• Positive stops are provided in the fully opened and closed
positions
• There is a minimum clearance between the bottom
edge of gate and ground. See Fig. 6a (where ‘S’ =
thickness of guide bracket)
The FAAC 770 is an electromechanical operator for swing
gates. It is designed for in-ground installation and therefore
does not alter the appearance of the gate.
The supplied support box allows you to setup the gate before
actually installing the operator.
The 770 electromechanical operator is not reversible, so it
ensures a mechanical stop and eliminates the need for an
electric lock.
The 770 Operator is designed and manufactured to au-
tomate vehicular swing gates. Do not use for any other
purpose.
Operator Cable Size
2x AWG 14 (max 30’)
AWG 12 (max 50’)
AWG 10 (max 100')
12⅛
17
6⅛
8½
Fig. 3
* Measurements in Inches
770 OPERATOR
1. DESCRIPTION AND SPECIFICATION
1.1 Technical Specifications
1.2 Electrical Setup
2. INSTALLATION
1.3 Dimensions
Always separate the connection cables of the low voltage
accessories from the high voltage power cables. Use separate
conduits to avoid interference.
The installer is responsible for grounding the gate and operator
systems, for providing the main power breaker switch, and for
making sure that the entire gate system meets all applicable
electrical codes.
Make sure to locate all controls that operate the gate system at
least 6 ft away from any moving parts.