FAAC C850 - Inverter Control Panel Functions; Inverter Key Functions Explained

C850 29 532015 - Rev.B
Translation of the original instructions
ENGLISH
Name Description
Mode key
Lets you go to the following modes: monitor (
d000), basic operation (F000)
and extended operation (
A000, b000, C000, H000).
This key also lets you change visualisation as shown below.
[Further information]
To go from “d001” mode to any operating mode, press and hold the
Mode key for 3 seconds.
o
Note: always press “enter” to store modifi ed data.
ENTER key
Enters and stores modifi ed data.
(To change the set value, remember to press Enter)
Do not press Enter if you do not wish to store changes
(e.g. when a change is made inadvertently).
Increase key
Changes the mode.
Also, it increases the set value of each function.
Decrease key
Changes the mode.
Also, it decreases the set value of each function.
F001F001
581
580
579