C850 8 532015 - Rev.B
ENGLISH
Translation of the original instructions
5.3 MECHANICAL INSTALLATION
1. Lift the cover to remove it (Fig. 8 ref. ).
2. Position the operator on the foundation plate and secure it without
tightening the nuts, Grover screws and washers supplied with
the foundation plate (not provided) (Fig. 9 ref. ). When
doing this, run the cables through the provided opening (Fig.
9 ref. ).
3. Use the adjustment screws to set the height of the gearmotor (Fig.
10 ref. ), referring to the measurements in Fig. 12.
4. Use a level to ensure that the gearmotor is perfectly horizontal.
5. Move the gearmotor horizontally to adjust the distance from the
rack (Fig. 11), referring to the measurements
in Fig. 12.
These operations are necessary to correctly
secure the rack and to make possible future
adjustments.
6. Once the adjustment is completed, tighten the nuts temporarily
(Fig. 9 ref. and Fig. 10 ref. ):
7. Prepare the gearmotor for manual operation, as described in
paragraph 8.
Fig. 8
Fig. 9
Fig. 10
Fig. 11
Fig. 12
To Next Page
Loading...
