18
SLH - SLH LR
OK
9
OPEN A
RADIO 1
DL16
RADIO 2
DL17
OPEN B
-
MAX
20”
(MASTER)
2 x 2”
1”
> 5”
+
RADIO 1
DL16
lampeggio · flash · clignotement
· Blinksignal · destello · knippert ·
ON OFF
·
OPEN A OPEN B
OK
9
1”
MAX
5”
RADIO 1
DL16
P1 + P2
(MASTER)
> 30 cm
RX
TX
햲
햳
햴
+
ENGLISH
MEMORISING THE RADIO CODE
The control board features an integrated 2-channel decoding system (DS, SLH/SLH LR, RC) called OMNIDEC. This system lets you memorise,
using an additional receiver module (on
J5 connector) and more radio controls having different technology but the same frequency. You can
thus control both total opening (OPEN A) and partial opening (OPEN B).
The procedures indicated in this paragraph are only valid for the OMNIDEC system (receiver inserted on connector J13.) See
the relative instructions for standard decoding boards (inserted on J14).
The different types of radio code (DS, SLH/SLH LR, LC/RC) can coexist simultaneously on the two channels. You can enter
up to 250 radio codes divided between OPEN A and OPEN B/CLOSE.
To use different encoding systems on the same channel, you must complete the learning of each encoding system and then
repeat the procedure for the other one.
Other, more detailed, programming options are available using a PC/MAC (see dedicated PC/MAC instructions). For example,
you can set an automatic OPEN command on the radio channel to command an automatic cycle (open-pause-close) regardless
of the selected logic.
MEMORISING THE SLH/SLH LR RADIO CONTROLS
1. Press and hold + (OPEN A programming) or - (OPEN B/CLOSE programming).
2. After keeping the button pressed for about 5 sec, the corresponding radio LED (DL11 or DL12) will begin to flash slowly for about 20 sec.
3. Release the button.
4. Simultaneously press and hold P1 and P2 on the
SLH/SLH LR radio control (only MASTER radio control).
5. The radio control LED will begin to flash.
6. Release both buttons.
7. Ensure that LED DL11 or DL12 on the board is still flashing (see point 2) and, while the radio control LED is still flashing, press and hold
the desired button on the radio control (the radio control LED will go on steady).
8. The corresponding LED on the board (DL11 or DL12) will go on steady for 1 sec and then go off, indicating that memorisation has been
completed.
9. Release the radio control button.
10. To complete memorisation, press the button of the memorised radio control twice in succession. The automated system will perform an
opening cycle.
Ensure that there are no obstacles (by people or things) during the automated system movement.
To Next Page
Loading...
