FAAC E145S - Table of Contents

Page | 1
Installation Sequence ........................................................................................................................................................ 2
E145S LED Display at first Power On ................................................................................................................................. 3
J11 Terminals ................................................................................................................................................................ 3
J3 Terminals .................................................................................................................................................................. 3
Electrical Connections ....................................................................................................................................................... 4
Connection of Traditional Photocells ............................................................................................................................ 4
Connection of FAAC BUS 2Easy Photocells ................................................................................................................... 5
Connection of FAAC BUS 2easy Safecoders and S800 Encoders .................................................................................. 5
Verification of BUS 2easy Connections on J10 Terminal .............................................................................................. 6
E145S Control Board Programming .................................................................................................................................. 6
Basic Programming ....................................................................................................................................................... 7
Set-Up – Time Learning (tL – function) ......................................................................................................................... 8
Advanced Programming ................................................................................................................................................ 9
E145S Signalling Errors and Alarms ................................................................................................................................. 10
E145S Operating Logics ................................................................................................................................................... 10
Programming Remote Controls using the XF Receiver and OmniDec ............................................................................ 11
Programming a new remote control to a new E145S System .................................................................................... 11
Programming a new remote control from a working master remote control ........................................................... 11
Tutorial Videos available for programming remote controls ..................................................................................... 11
These instructions are to be considered as a rapid guide for installation and to confirm the correct handing and polarity
of the motors. They can also be used to confirm the operating logics before additional safety devices are fitted to the
system as specified by the Risk Assessment undertaken by the installer. The installer should still familiarise
themselves with the full manual and the safety information contained within. (available at
https://www.faac.co.uk/accessories-and-control-boards/control-boards/for-swing-gates/e145S-control-board)