Page | 3
LED Display at first Power On
J3 Terminals
The new J11 Terminal to allow the direct connection of resistive safety edges or N/C safety inputs comes pre-linked and
configured to N/C setting, hence the relevant EDGE 1 or EDGE 2 LED being lit on first Power On.
DL7, DL6 and DL5 will only be illuminated if the following terminals are linked out (please note that the board comes with
links in place). The links are just to be used for test purposes only and safety devices should be wired in, as detailed in the
instructions further below. In no circumstances should the system be handed over to the end user with these links still in
place unless it is being controlled via Dead-Man operation and by trained users only.
To Next Page
Loading...
