FAAC E844 3PH - Default Chapter; Table of Contents

E844 3PH 1 532315 - Rev.B
Translation of the original instructions
ENGLISH
CONTENTS
EU Declaration of conformity ........................... 2
1. INTRODUCTION TO THIS INSTRUCTION MANUAL ..... 2
Meaning of the symbols used ........................... 3
2. SAFETY RECOMMENDATIONS ......................... 4
2.1 Installer safety ....................................... 4
2.2 Storage .............................................. 4
2.3 Waste disposal ....................................... 4
3. E844 3PH .............................................. 5
3.1 Intended use ......................................... 5
3.2 Limitations of use .................................... 5
3.3 Unauthorised use .................................... 5
3.4 Product identification ................................. 5
3.5 Technical specifications ............................... 5
4. INSTALLATION REQUIREMENTS ....................... 6
4.1 Electrical system ..................................... 6
5. INSTALLATION ........................................ 6
5.1 Tools required ........................................ 6
5.2 Components ......................................... 7
5.3 Connections ......................................... 8
Control devices ........................................ 8
Accessories power supply ............................... 9
Outputs ............................................... 9
Failsafe ................................................ 9
Limit switches ......................................... 9
Flashing light .......................................... 9
BUS 2easy devices ....................................10
Radio receiver/decoder board .......................... 10
Motor ................................................10
Connecting the earth ..................................10
Mains power supply ................................... 10
6. SET-UP ...............................................11
6.1 Programming .......................................11
6.2 Operating logics ..................................... 13
6.3 Setup...............................................14
6.4 Restore the default values............................14
7. PUTTING INTO SERVICE ..............................14
7.1 Final checks ......................................... 14
7.2 Close the enclosure .................................. 14
7.3 Final operations ..................................... 14
8. ACCESSORIES .........................................15
8.1 Closing photocells ...................................15
8.2 Sensitive edges .....................................15
8.3 BUS 2easy devices ...................................16
Connection ...........................................16
BUS 2easy photocells .................................. 16
BUS 2easy control devices .............................17
BUS 2easy status ...................................... 17
BUS 2easy device registration ..........................17
Checking BUS 2easy devices ...........................18
9. DIAGNOSTICS ........................................18
9.1 Firmware version .................................... 18
9.2 Automated system status ............................18
9.3 Alarms/Errors .......................................18
9.4 LEDs check .......................................... 18
10. MAINTENANCE ...................................... 19
10.1 Routine maintenance ...............................19
TABLES
 1 Technical data E844 3PH .............................5
 2 Assigning an address to the Photocells .............. 16
 3 Addressing Sensitive Edges ......................... 17
 4 Addressing Control Devices ......................... 17
 5 Automated system status .......................... 18
 6 Alarms/Errors ..................................... 18
 7 Status of the LEDs ................................. 18
 8 Scheduled maintenance ........................... 19