13
Start-up
Remove the plastic strip from the batteries.
Select the type of mode to trip the alarm.
Close the enclosure and secure the screws.
Movement detector test
Press the detector’s push-button.
Pass in front of the sensor, in different areas of the
room where it is installed.
Each detection is signalled by a beep.
Immediate alarm:
Immediate alarm:
In case of detection, the alarm is tripped immediately
Dela
Dela
y
y
ed alarm:
ed alarm:
The alarm is tripped with a delay of about 45 seconds,
to allow the user to disable the alarm after entering
(example: disabling the system from the control
keypad fitted on the wall).
Duration of test mode: about 5 min.
When this time has elapsed, press the push-button
again if you wish to continue the test.
Installation
To Next Page
Loading...