Installing the system devices
12
Selecting the position
The movement detector should preferably be located
in a corner:
- avoid any heat source, or movement of a warm body,
near the sensor (convector, fireplace/chimney…),
- the detection field must be free of any obstacles
(curtains, furniture…),
- the sensor must not point at an external opening
(window),
- the beams of two sensors can be made to cross over,
- the sensor should preferably be installed between
2.20 and 2.40 m off the floor.
Opening on the outside
Detector
Convector
Detection range (top view)
Route direction
perpendicular with
respect to radius
Install at least 1 meter from
a convector
Installation at
a height of 2.3
m off the floor
1
2
Parts to eliminate
Secured on an articulated joint
1- Secure the
articulated joint
2- Secure the sensor
on the articulated joint
Wall
Secured on a wall
Holes for securing
the sensor at 2.3 m
off the floor
Holes for securing
the sensor at 3 m
off the floor
0
3
5,2
7
11
12 m
5,7˚
10,5˚
90˚
Detection range (top view)
Coverage angle
90˚ maximum
0
12 m
Detection range (side view)
2,3 m
1,2 m
3
5,6
Height: 2.30 m
Range: 12 m
Secured in a corner
Holes for securing
the sensor at 2.3 m
off the floor
Holes for securing
the sensor at 3 m
off the floor
Securing
Unfasten the enclosure closing screw.
Select the position where to locate the movement
detector: it can be placed in a corner, on the wall, or on
the supplied articulated joint.
Installation
To Next Page
Loading...