FAAC HOME SHIELD - Creating Surveillance Areas

Creating surveillance areas
After you have typed in the access code for displaying
the system’s current status, press the configuration
push-button.
Select the LEARNING menu, and then confirm.
As soon as learning has finished, select the
INSTALLATION menu and then confirm.
The message OPEN THE CONTROL UNIT
COMPARTMENT is shown, if this compartment is not
already open. You have one minute to open it.
- select the CREATION menu and the area (the digit
under the house), and then confirm.
The display shows XX-- -- -- --.
- press the test push-button of every device to be
associated with the selected area (not including
technical detectors and control devices).
The control unit sounds a BEEP for every selected
device.
- after you have selected all the devices of the area,
press to return to the CREATION menu.
Repeat the same operations for the different
surveillance areas.
C
C
INFO
INFO
OK
+
-
O
K
O
K
+
-
C
INFO
+
-
O
K
O
K
+
-
C
INFO
OK
O
K
O
K
+
-
C
INFO
+
-
O
K
O
K
+
-
C
IN
FO
IN
FO
+
-
Select a device by pressing
the relevant TEST push-button
O
K
O
K
+
-
C
INFO
OK
O
K
O
K
+
-
C
INFO
OK
Example:
creation
of area 1
C
INFO
OK
+
-
C
Impor
Impor
tant:
tant:
A device can be associated with several surveillance
areas or none. The alarm can be enabled in one area
at a time.
21
Customising