31
By remote-control
Enabling and disabling the alarm
- Press the ON key to enable the alarm mode on,
- Press the OFF key to disable the alarm.
To eliminate the signalling of an alarm memory-stored,
press OFF for 10 seconds.
Enabling the alarm
Type in the access code and confirm.
On the display, the symbols and indicate that
the alarm is disabled.
Using push-buttons and
,
select the type of
enablement you require (system mode on or area
mode, e.g.: area 1).
Confirm by pressing .
Disabling the alarm
Type in the access code and confirm.
On the display, the symbols and or
indicate that the alarm is enabled.
Using push-buttons and , select the
mode.
Confirm by pressing .
Disabling under threat
This function is used to make possible aggressor
believe that you are typing in the real keypad access
code, whereas a telephone call is tripped, without any
acoustic signal.
To do this, you have to add a unit to the first digit of
your keypad access code. (e.g.: access code “1234”,
code under threat “2234”. If the first digit is 9, select 0.
Consulting outdoor temperature
This function is accessible only if you have an outdoor
siren, connected to the system.
To read the external temperature:
- without typing in the access code, press
.
- the external temperature is displayed.
To Next Page
Loading...